Plumbing, planned and delivered end to end.

Pipe Installation & Repair

New pipework for homes, commercial buildings and plants — hot and cold water, drainage, and concealed bathroom and kitchen lines — and repairs to the pipework that is already there.

• Hot- and cold-water supply lines
• Concealed bathroom and kitchen plumbing
• Drainage, waste and vent lines
• Leak repair, re-routing and re-piping

System Maintenance & Inspection

Planned inspection and servicing of the plumbing you already have, so small faults are found and put right before they turn into leaks, low pressure or a shutdown.

• Leak and pressure checks
• Servicing of valves, pumps and fixtures
• Flushing of lines, strainers and filters
• A clear list of what needs attention

Industrial Boiler Services

The water side of a boiler house — feed-water and condensate lines, the valves and pumps around the boiler, and its water-treatment connections — installed and looked after so the plant keeps running.

• Feed-water and condensate pipework
• Boiler-house valves and pumps
• Water-treatment connections
• Inspection and maintenance support

Valve & Pump Solutions

Pumps, headers and valves installed, connected and serviced — from a building’s transfer and booster pumps to plant-room headers with their isolation and control valves.

• Pump installation and connection
• Isolation, non-return and control valves
• Pump-room headers and manifolds
• Servicing, repair and replacement

Process Piping Systems

Pipework for industrial units — cooling-tower circuits, water-treatment skids, process-water distribution and compressed-air lines — laid out for the plant it serves.

• Cooling-tower circuits
• Water-treatment and filtration skids
• Process-water distribution
• Compressed-air headers and drops

Emergency Response Services

When a pipe bursts, a drain backs up or a pump stops, call us. We help isolate the fault, limit the damage and get the water running again.

• Burst and leaking pipes
• Pump and valve failures
• Blocked drains and overflows
• Isolation and temporary fixes to restore supply

The pipe systems you’ll see in our work.

Each chosen for the line it has to carry — water in a bathroom wall, a cooling-tower circuit, air on a shop floor.

• Stainless steel, press-fit — Hot- and cold-water lines in stainless steel, joined with press fittings — a clean, strong run for concealed bathroom plumbing.
• Multilayer composite — Composite pipe bends in long sweeps, so a run to a mixer or a manifold needs fewer joints hidden inside the wall.
• PP-R, fusion-welded — Green PP-R pipe, heat-fused at every joint — the pipe in our cooling-tower circuits, pump rooms and process lines.
• Compressed-air lines — Air headers with a drop and a valve for each machine, carrying compressed air around the shop floor.

Not sure which service you need?

Describe the problem or the project — we will tell you what it involves and where to start.